Tinkering Again

As the power supply for my transmitters resides under the desk I have a separate volt meter so I can check that all is working as it should.  My old LED one had some failed LEDs so I bought a cheap LCD one to replace it. The bare unit needed something to hold it in place so after 30 mins in TinkerCad I came up with:



The instruction were copied to Ultimaker Cura to produce a file for the 3D printer.
Unit rotated to print face down. No supports needed that way round.



2hr 34 minutes later it was ready to fit the meter:



Had to do a bit of minor filing as the hole was about 0.5mm too small but soon it was mounted, wired up and connected:



All done.